The basic 2 LED astable multivibrator flasher built by Mary. She chose to use 2 different colored LEDs and the red LED is clear when unlit. It is quite bright when lit compared to the yellow LED despite the fact that it only draws 0.5 mA more. The bread boarded test circuit was powered by a new 9 volt battery and was regulated by a L78L05 (in a TO-92 package as shown in the schematic). The 5 volt regulator was used to avoid exceeding the reverse breakdown voltage of the 2N3904. This topic will be discussed a little later on. 470 ohm current dropping resistors were chosen to keep the collector current draw less than 10 mA. The LEDS were bright enough to see well in dim lighting. You may change this resistor "R" value (lower R = brighter), but do not exceed the maximum current rating for the LED or transistor (this is more applicable to higher voltage multivibrators). You may also place 2 or more LEDs in series on each half of a multivibrator, however, the current dropping...