My Circuit

Here I will explain about the necessary voltage and power amplifier output. The voltage should have at least approximately 9Volt 30Volt voltage and maximum voltage on the DC current. For maximum output of 2 X 2Watt with impedance 8-16 ohm. Because this amplifier circuit using ic and ic is used have the equation, so that if used different ic, then the required output voltage and also differ depending ic respectively. Part List : Resistor R1 = 1M R2 = 1M R3 = 1K R4 = 1K R5 = 100K R6 = 100K R7 = 1R R8 = 1R Capacitor C1 = 1uF C2 = 220uF C3 = 1uF C4 = 100uF C5 = 5uF C6 = 5uF C7 = 0.1uF C8 = 220uF C9 = 220uF C10 = 0.1uF IC U1 = ULN2274B , ULN2277 , ULN2278B

Battery Charger This circuit can be charged the 12 nicad battery , and the circut charger at 75mA until  until the battery is fully , when the battery is fully the voltage to be down . This charge can charged fully in a hour , because the charge can't quickly charged , But the charge can stabilized output voltage. See this charger schematic below :

Below its a converter circuit voltage from 6 Volt to 12 Volt DC. 6 Volt to 12 Volt DC Part List : R1, R4 2 .2K 1/4W Resistor R2, R3 4.7K 1/4W Resistor R5 1K 1/4W Resistor R6 1.5K 1/4W Resistor R7 33K 1/4W Resistor R8 10K 1/4W Resistor C1,C2 0.1uF Ceramic Disc Capacitor C3 470uF 25V Electrolytic Capcitor D1 1N914 Diode D2 1N4004 Diode D3 12V 400mW Zener Diode Q1, Q2, Q4 BC547 NPN Transistor Q3 BD679 NPN Transistor L1 See Notes Notes 1. L1 is a custom inductor wound with about 80 turns of 0.5mm magnet wire around a toroidal core with a 40mm outside diameter. 2. Different values of D3 can be used to get different output voltages from about 0.6V to around 30V. Note that at higher voltages the circuit might not perform as well and may not produce as much current. You may also need to use a larger C3 for higher voltages and/or higher currents. 3. You can use a larger value for C3 to provide better filtering. 4. The circuit will require about 2A from the 6V supply to provide the full 800mA at...

This circuit is a DC voltage output from a small DC input generate large voltage.It ‘s easy and quick to do, and reducing the value of the Z-diode, the circuit can be universally adapted to other output devices of the circuit voltages. The give and all diagrams represent a DC converter with 12V battery 9 volt DC input and output.     12-9 Volt DC to DC Converter Circuit Diagram With the 10V zener diode, as in the diagram, the output voltage is approximately 9.3 volts DC. The supply voltage is used, should always be at least a few volts higher than the Zener voltage. In this example, I have a 12 Volt DC battery to provide regulated 9-volt DC output.